Free tools for scale service
Scale tolerance calculator (NIST Handbook 44)
Maintenance and acceptance tolerances for any test load, from Handbook 44 Section 2.20 Table 6 (2026 edition), with pass/fail for your readings and the decreasing-load and shift test loads for the scale. Acceptance tolerances are one-half the maintenance tolerances.
Scale
Results
| Load | In e | Maint. ± | Accept. ± | Error | Result |
|---|---|---|---|---|---|
| 5 | 500 | 0.01 (1 e) | 0.005 | 0 | PASSwithin acceptance |
| 20 | 2,000 | 0.02 (2 e) | 0.01 | +0.01 | PASSwithin acceptance |
| 40 | 4,000 | 0.03 (3 e) | 0.015 | -0.02 | PASSmaintenance only |
| 60 | 6,000 | 0.05 (5 e) | 0.025 | +0.04 | PASSmaintenance only |
Acceptance tolerances apply to equipment put into commercial use for the first time, and to equipment officially tested for the first time within 30 days of being placed in service, of corrective service after rejection, or of major reconditioning (General Code G-T.1). Maintenance tolerances apply to equipment in use otherwise (G-T.2). Not covered: Class IIII wheel-load weighers (double tolerances), crane and hopper scale minimums, multi-interval scales.
Test plan for this scale
- Decreasing-load test loads
- 60 lb → 40 lb → 20 lb → 5 lb
- The largest test load at each tolerance step (N.1.2.1).
- Shift test load
- 18–21 lb at the centre of each quadrant
- One-third capacity (30–35 %); over 500 kg / 1000 lb, one-quarter capacity on each corner is allowed instead (N.1.3.7).
The method behind it
Test every scale this way, then the report writes itself
Certorum runs scale testing for registered service agencies: Handbook 44 tolerances checked as you enter each test load, as-found and as-left results, test weights on record, placed-in-service reports and invoices. Free for up to 40 scales.